Nova Bath Transfer Board Installation Instructions

• Unscrew knobs from foot assembly
• Place knob through the slots so knob handle is facing upward
• Install anti-slip rubber pad into anti slip pad insert located on the bottom of the bath board next to the open slots
• Loosely assemble the four foot rest assemblies to the shower board through the slots by placing the knobs on top of the board and the rubber stops underneath, and then screwing the two pieces together
• Be certain the inner walls of the tub are free from dirt, grease or soap build-up
• Place the tub board on top of the tub with the soap dish closest to the wall, away from the side of entry
• Position the rubber stops of each foot assembly against the inner wall of the tub
• Tighten each knob from the tip while pushing the rubber stops against the inner tub wall
• Check the knobs periodically to insure rubber foot assemblies are securely tightened to tub walls

Nova Bath Transfer Board Safety and Care Instructions

• Do not use red safety handle as a weight support when sitting or standing
• Check the red handle periodically ti insure grab bar is securely tightened to the bath seat
• Extreme caution should be used on wet surfaces
• Persons with limited physical/mental abilities should be assisted during bathroom activities
• Clean with soap and water